RISCO Group GT 600 - Manual (Page 34)

Page 33
GT 600 601 User Manual
System G-Tag
G-Tag Readers are available in three variants, with the reader built into the display
area of an LCD RKP, as an Internal Stand alone Reader or as an External Stand alone
Reader. When using G-Tag, the system may be Set / Unset by presenting a valid Tag
to one of the Readers.
Each Tag is programmed onto the system as an individual User Code therefore giving
indication via the system Log of who has set and unset the system. As the Tags are a
close proximity device, the risk of code capture is eliminated.
When programming the G-Tags, follow the normal Programming Codes instructions to
the point when you are asked for the Code, for example:-
At this point, present your G-Tag to the reader and the code will be entered.
4 Wire Keypad
Each G-Tag need only to be programmed onto one of the 4 wire keypads in multiple
reader installations.
6 Wire Keypad
If you have more than one keypad on your system, the G-Tag MUST be programmed
into each of the keypads on the same User Number. Because of this, it is essential
that you use good housekeeping for the G-Tags. Mark each of the G-Tags and record
what User Number the G-Tag has been allocated to.
Now Enter Code . .
- - - - - - Then YES
600 601 PR600601_1_10user.qxd 25/08/2010 11:53 Page 33