RISCO Group GT 600 - Manual (Page 46)

Page 45
GT 600 601 User Manual
Display Blanking
Depending on the level of your system and the legislation that it is required to comply
with your installation company may have initialised Display Blanking. When this is used
the Status of the system will only be indicated on the display for ten seconds after it
has been Set and for ten seconds after it has been Unset.
The Status of the system may be shown by following the procedure below. Please note
Control Codes or Group codes cannot be used for this feature.
1) When the system has just been Set the display
will show for example:-
For ten seconds
2) The display will then show for example:-
3) To show the Status of the system Press YES
The display will show for example:-
4) Enter a valid Code to display the Status for
a further ten seconds.
End User Training
It is the responsibility of your Installation Company to provide adequate training for
people who will be expected to use the system. If further training is required for new
staff etc please contact your Installation Company. This user Manual should be
accessible by all people who will be using the system. If extra copies are required the
manual may be downloaded from our web-site www.riscogroup.co.uk
Testing /Servicing Your System
The system you have installed will give many years of service but it should be tested
and serviced on a regular basis by a qualified installation engineer. It may be a
condition of your insurance policy and/or your Police response that it is serviced at
regular intervals. For details on service periods for your system please contact your
installation company.
< < SET1 > >
01 JAN 18 : 58 : 01
01 JAN 18 : 58 : 01
Press . .
CODE : Show Status
600 601 PR600601_1_10user.qxd 25/08/2010 11:53 Page 45