RISCO Group GT 600 - Manual (Page 7)

Page 6
GT 600 601 User Manual
Setting The System
1) With the display showing:-
2) Enter your User code.
(Followed by YES if a Master or Main type code
has been used). The display will show:-
and a continuous exit tone will sound.
(See “Pre Exit Check” note below and/or “Pre Exit
Check in Wireless Installations” on page 7)
Note: Count down in display depends on the setting mode programmed by the Engineer.
3) Exit the premises via the authorised exit route.
(The exit tone will change if any detectors are violated during exit).
4) Once the premises are secure listen, (from outside
the protected area) that the exit tone returns to the
continuous tone.
5) Wait until the exit tone finishes before leaving.
Note: 1 Setting the system with an area code will set only the area(s)
associated with that code.
Note: 2 Setting an unset system with a cleaner code will set the full system.
Note: 3 To Set the system with cleaner on site Press CODE YES YES 0
Pre Exit Check
At the start of the setting procedure any non exit routes that
are open will sound a fault tone. The display will show, for
example:-
If the fault clears within 20 seconds then the exit will begin,
otherwise the display will return to Day (Unset) Mode.
EXIT ! 1
All Zones ON 15
01 JAN 18 : 58 : 01
Time will count down
Zone 008 12hr
All Zones ON
600 601 PR600601_1_10user.qxd 25/08/2010 11:53 Page 6