RISCO Group Gardtec 490X - Manual (Page 59)

Page 58
GT490X Engineer’s Reference Guide
Programming Linefault Modes
1) Enter into Engineer Mode
To do this follow Steps 1 to 4 on page 18
With the display showing:-
2) Press No six times. The display will show:-
3) Press Yes. The display will show:-
4) Press Yes. The display will show:-
5) Press No until the required setting is displayed
then press Yes. The display will show:-
6) Press No. The display will show:-
7) Press Yes. The display will show:-
8) Press No until the display shows the required setting
then press Yes. The display will show:-
Program . . . . _ _ _
Zones ?
Program . . . . _ _ _
Linefault Modes ?
Program Linefault
Sounders ?
Linefault Sounders
=ON if Un-Set
Program Linefault
Sounders ?
Program Lineflt
Mode in Exit ?
Program Lineflt
Mode in Exit ?
Lineflt Mode . . .
= Detect in Exit
PR5851 Rev12 490X Eng Ref Guide.qxd 10/05/2012 11:33 Page 58