RISCO Group Gardtec 490X - Manual (Page 63)

Page 62
GT490X Engineer’s Reference Guide
Programming PGM2 / 3 / Timers
PGM2 refers to the PGM2 terminal on the control panel PCB situated near to the RKP
terminals.
PGM3 Refers to the Strobe terminal, if this is not used for the Strobe (for example if a
NovActive Bell Box is used) it may be re-programmed for other uses.
One Timer is also available. It should be noted that the times programmed will operate
seven days per week, you are not able to program separate time for weekends etc.
1) Enter into Engineer Mode
To do this follow Steps 1 to 4 on page 18
With the display showing:-
2) Press No eight times. The display will show:-
3) Press Yes. The display will show:-
4) Press Yes. The display will show:-
Options available for PGM2 / 3 are.
Bell
Strobe
Latch Any
Any Digi
Status
Perimeter
Zone Exclude
Custom 1 to 8
Int. Sounder
E/E
Timed 1
Alert
Program . . . . _ _ _
Zones ?
Program . . . . _ _ _
PGM2 / 3 / Timers ?
Program PGM2 / 3
Operating Modes ?
PGM2 O/P
= Bell
= +V
PR5851 Rev12 490X Eng Ref Guide.qxd 10/05/2012 11:33 Page 62