TA Triumph-Adler FAX 941 - Manual (Page 108)

Maintenance
6-23
Op
er
atio
n
Se
ttin
g y
ou
r
mach
ine
Ge
tti
ng
sta
rt
ed
Direc
to
ry
Ma
inte
na
nc
e
Sa
fe
ty
Co
nt
en
ts
Insta
lla
tio
n
Date en cours : 12 juillet 2004
\\Sct01002\Be31-doc\DOC 31 - En cours\Travaux en cours\Fax\MFL V 2\LU 251 524 337A MFL_V2 LASER PRO 346_348 GB\Maintenance
Gb.fm
M
ISCELLANEOUS INCIDENTS
At switch-on nothing appears on screen
Check that the mains cable is plugged in, and check the mains plug if necessary.
The fax does not detect the presence of your inserted document. The message READY does
not appear on the screen.
At the start and during scanning,
REMOVE DOCUMENT appears on the screen.
Remove the document or press key .
Check the thickness of the document (30 sheets of paper of 80 g/m
2
).
Iron out the sheets if needed.
Help the sheets along.
The fax machine does not receive any faxes
Check that the telephone line cable is correctly plugged in and that there is a tone signal on the
telephone line by means of the
key.
You receive a blank page
Make a photocopy of a document ; if it is correct then your fax is functioning normally. Call back
the subscriber and have him resend the document. It was probably sent with the sheet inserted
backwards.
You cannot send a fax
Check that the telephone line cable is correctly plugged in.
Check the tone by pressing key
.
Check the prefix is correctly programmed and used.
M
ACHINE PACKING AND TRANSPORTATION
Always use the original package when transporting the machine. Failure to do so could void the
warranty.
 1 - Disconnect the machine from the telephone network and the AC power socket.
 2 - Open the front cover.
 3 - Shut the front cover. Unplug the phone line cord and the AC power cord, the document
holder and the document stacker. Put them in the original package.