TA Triumph-Adler FAX 941 - Manual (Page 76)

Operation
5-13
Op
er
atio
n
Se
ttin
g y
ou
r
mach
ine
Ge
tti
ng
sta
rt
ed
Direc
to
ry
M
ainte
na
nc
e
Sa
fe
ty
Co
nt
en
ts
Insta
lla
tio
n
Date en cours : 12 juillet 2004
\\Sct01002\Be31-doc\DOC 31 - En cours\Travaux en cours\Fax\MFL V 2\LU 251 524 337A MFL_V2 LASER PRO 346_348 GB\Operation Gb.fm
By entering new values of X and Y given in mm (X < 210 and Y < 286), you will move the
scanning zone as shown on the figure below.
 Select the X and Y coordinates with keys or
 Set the required coordinates with the numeric keypad or or
 Confirm your setting by pressing key OK
Contrast
 Set the desired contrast with keys or
 Confirm your setting by pressing key OK
Luminosity
 Set the desired luminosity with keys or
 Confirm your setting by pressing key OK
Margins
If you want to shift the side margins of your document to the left or to the right:
 Adjust the left / right margins shift (in steps of 0.5 mm) with keys or
 Confirm your setting by pressing key OK
Printer settings
Paper
 Select the type of paper NORMAL or THICK with keys or
 Confirm your setting by pressing key OK
Remarks : 1) When the THICK type of paper is selected, the printing speed is slowed down.
2) Use the manual feeder for paper substances over 90 g/m
2
.
Paper tray
 Select the paper tray to be used ( AUTOMATIC , LOWER or UPPER ) using keys or
 Confirm your setting by pressing key OK
scanned area
Top view: scanned side down
y
x
T
O
P OF SH
E
E
T
EN
D
O
F
SH
EET