PLANET NAS-3410 - Manual (Page 96)

Discovering NAS-3410
When startups, NAStart automatically discover all the NAS-3410s on the network and display a list
of server under the node Local Server. NAStart will automatically refresh the server list at a
specified interval. The default interval is 10 minutes.
NAStart can also locate NAS servers by IP addresses. It is useful when NAS servers are on the
Internet or located in different network segments from the NAStart. To locate NAS servers by IP
addresses, select Remote NAS List from the File menu. Click the Add button and enter the IP
address of the NAS server.
To set the automatic refresh interval
1. Go to Tool Æ NAStart Options menu.
2. Enter a number between 1 to 60 minutes.
3. Click OK.
Server Quick Setup Using NAStart
You can perform initial setup for your NAS-3410 using NAStart.
1. Click the button on the toolbar.
2. Or, go to Server -> Server Quick Setup.
3. Select a NAS Server from the server list and click Next button.
4. Choose the Network Teaming Mode from the pull down menu. If you are not clear about this
feature, continue with the default value.
5. If you want the IP settings to be assigned automatically, click Obtain IP settings
automatically.
6. Or, you can specify the IP settings manually.
7. Click Next button to go to the next page.
8. Enter the Server Name, Server Comment, and Workgroup/Domain Name and select either
the Workgroup mode or Domain mode. Note that this is the server name as it appears on
the network which is irrelevant to the network protocol used.
9. Click Next button to go to the next page.
10. Change the admin password if necessary.
Click the OK button to save the settings. Note that server may need to reboot for certain
parameters changes to take effect.
92