Escort 3016B - Manual (Page 110)

15 Ethernet interface
Page 12
14.5.2.Parameters of the channels
HEADER PARAMETERS EXAMPLES
CHAnnel P1 CHAN B3
Defines the CHANNEL to be modified by the following commands A modification of the channel 3 of the
board B has been chosen
P1 = channel choice (A1,A2, etc?
CHAnnel ? Returns the selected channel number and its value
VALID P1,P2 VALID ALL,OFF;CHAN A1 ON;CHAN
LOG,ON
Defines the channel validity
P1 = ALL for all the channels
A1,A2, etc... For each channel
LOG for logical channels
P2 = ON or OFF
VALID ? Return sthe validity of all the channels
NAMe P1 CHAN B3;NAM 'oven1'
Modify the CHANNEL name
P1 = name ( maximum 26 caracteres ) beetween " or '
NAMe ? Returns the CHANNEL name
TYPe:VOLtage P1 TYPE:THERM K,COMP
Modify CHANNEL type to voltage
P1= DC or RMS
TYPe:SHUNT P1,P2
Modify CHANNEL type to current shunt
P1 = DC or RMS
P2 = S1M,S10M,S01,S1,S10,S50 ( for 1mOhm, 10mOhm ,0.1
Ohm, ... 50 Ohm)
TYPe:FREQ Modify CHANNEL type to frequency
TYPe:PT100 P1,P2
Modify CHANNEL type to PT100
P1= W2, W3, W4 for 2 wires, 3 wires or 4 wires
P2= Resistor value ( in 1/10 of ohms)
TYPe:THErmo P1,P2
Modify CHANNEL type to thermocouple
P1= Thermocouple = J,K,T,S,B,E,N,W
P2= NOCOMP or COMP
TYPe ? Returns the type of CHANNEL
UNIt P1 UNIT CEL
Temperature unit for types thermocouple and PT100 Unit Celsius degree
P1: CEL,FAR,KEL
UNIt ? Returns the temperature unit of CHANNEL
FILter P1 FILTER 10HZ
Defines the filter of CHANNEL
P1 = WOUT,F10KHz,F1KHz,F100Hz,F10Hz, F1Hz,F10S,F100S or
F1000S
FILter ? Returns the filter of CHANNEL
RANge P1,P2,P3 RANGE 12,3,0
Modify the range and the center (zero) of CHANNEL range = 12 Volts
center = 3 Volts
P1 = range in ISO unit (Volts or ) in real number
P2 = center in ISO unit in real number
P3 = Position in %
RANge ? Returns the range and the center of CHANNEL
Use of a compensated thermocouple K
Valid channel A1 and logical channels