Escort 3016B - Manual (Page 118)

15 Ethernet interface
Page 20
14.5.15. Service request
See the explanations about the structure of status data.
14.6. Error messages
When a problem arouses in the programming via the interface of the recorder, a Debug window is
displayed on screen to help you identify your error:
Each error is associated with a line that shows:
- an error number
- the received message
When the window is full, the errors are displayed again from the 1 st line on.
The last line is followed by a blank line.
HEADER PARAMETERS EXAMPLES
SRQ_ENABLE P1 SRQ_ENABLE 3
Allows to modify the alarm enable register
P1 = register value
3 = 1 + 2 (bits 0 and 1)
Start and End of plot events are
authorized to be indicated in the status
byte register (bit 0).
bit decimale value use
0 1 start of plot
1 2 end of plot
2 4 end of write
3 8 no more paper
4 16 door open
5 32 start of memory record
6 64 end of memory record
7 128 trigger of memory record
SRQ_ENABLE ? Returns the value of the alarm enable register
SRQ_TYPE ? Returns the value of the alarm status register. SRQ_TYPE ?
The register is cleared. the recorder returns : SRQ_TYPE 4
Each bit of this value is identical to the previously defined bit in
SRQ_ENABLE.
so "a write operation is completed"
Error N Explanation
1 Unknown header
2 Unknown parameter
3 Prohibited parameter
4 Missing parameter
5 Incorrect parameter separator
6 Incorrect message separator
7 Too long word
8 Incorrect format of text parameter
9 Prohibited query
10 Numerical parameter out of limits
11 Text parameter out of limits
12 Obligatory query
13 Transmission buffer full
14 Not possible in this contexte
15 Checksum error