Escort 3016B - Manual (Page 35)

4 Use
Page 6
4.5. Channels set up key
Configuration of the channels. After pressing this key, select a module, then select a channel to
access its parameters.
4.5.1. Analogical channels
 Name: give a name to the channel (max. 26 characters)
 Type: choice of the type of measure made on this input
- voltage, intensity, frequency or thermocouple
- direct or RMS
- value of the shunt in intensity measurement
- choice of the type in thermocouple, compensation, unit
 Filter: positioning a filter at the inlet
- 10 kHz, 1 kHz, 100 Hz, 10 Hz for analogical filters
- 1 Hz, 10 s, 100 s or 1000 s for digital filters
 Function: makes it possible to assign a mathematical calculation function to the considered
channel
- Without: no function.
- Change unit: modifies the unit of the measures on the channel; you can then
program a couple of dots X1, Y1 and X2, Y2 to achieve a scaling
- Calculation: available mathematical functions, associated parameters and unit