Escort 3016B User Manual
Page 112
15
Ethernet interface
Page 14
14.5.6.Chart
HEADER
PARAMETERS
EXAMPLES
DIRECTPLOT
P1
DIRECTPLOT FT
P1 = FT, TEXTe
F(t) mode in real time has been selected
DIRECTPLOT ?
Returns the plotting mode on paper
SPEed
P1,P2
SPEED 10,MM_S
Paper speed definition
Speed of 10 mm/sec
P1 = speed value :
1,2,5,10,20 for P2 = MM_H ou MM_M,
1,2,5,10,20,25,50,100,200 for P2 = MM_S
P2 = units
MM_S (mm/second)
MM_M (mm/minute)
MM_H (mm/hour)
SPEed:LOGEXT
P1 : Impul/mm speed definition
SPeed ?
Returns the command status of SPEED or SPEED:LOGEXT
BASESPeed:NONe
Base speed equals zero
BASESP:SPE 1,mm_H
BASESPeed:SPEed
P1,P2
Speed before trigger 1mm/hour
Allow to modify paper speed before trigger
P1 = speed value (see SPEED)
P2 = Unit (see SPEED)
BASESPeed ?
Returns paper speed before trigger
TEXTSpeed
P1,P2
TEXTSPEED 2,SEC
Defines the writing period in text mode
P1 from 1 to 500
P2 is Sec, MIn or HOurs
TEXTSpeed:EXT
Defines the external writing period
TEXTSpeed ?
Returns writing period in text mode
GRATicule
P1,P2
GRAT G5,C
Defines the paper grid
P1=WOUT,G5,G10 or DIV defined the kind of grid
P2=Fine or Coarse
GRATicule ?
Returns the command
CHART:TITle
P1
CHART:TITLE "OVEN 12"
Defines the acquisition title
P1 =message beetween '
CHART:TITle ?
Returns the acquisition title
CHART:DATe
P1
CHART:DAT ABS
Defines the paper datation
P1 = ABSolute or RELative
CHART:DATe ?
Returns the command
CHART:BOUndary P1
P1
CHART:BOU WITH
Defines the writing boundaries at the end of the plot
Ecriture des bornes
P1 = WITH or WOUT
CHART:BOUndary ?
Returns the command
ANNOte
P1,P2
ANNOT LEN,20
Defines the annotation mode
P1 = WOUT,START,ALarm or LENgth
Annotation every 20 cm
ANNOte ?
Returns the command
ANNOte:TYpe
P1,P2,P3
ANNOT:TYpe NAME,NUM,VALUE
Writing of names of channels
P1 = NONAME or NAME writing channels names
P2 =NONUMber or NUMber writing channels numbers
P3=VALue,RANge,SCAle definition of type of annotation to write
ANNOte:TYpe ?
Returns the command
WRIte
P1
WRITE 'RECORDER'
Immediat writing of the message on the paper
P1 = message (max 93 caracteres) beetween " or '
Defines the plotting mode on paper
P2 is the number of alarm ( from 1 to 3) or the paper length