Escort 3016B User Manual
Page 74
10 Go/Nogo mode
Page 2
Sample rate: sampling rate of the channels
-
internally rated from 1 s to 20 min
-
externally rated through the logical channel 16
Blocks: division of the internal memory into blocks
-
1, 2, 4, 8, 16, 32, 64 or 128
-
Raz Blocks: deleting all the blocks: the current block is the #1 block
Start: start condition of the acquisition
- Manual: with the F2 key Urge triggering
-
Trigger: with an association of the analogical or logical channels - see Chapter 6
Trigger
- Waiting for: after a delay or at a precise date and time
- Automatic: immediate; automatic stop when the block is full
Pre-triggering: definition of the position of the start trigger in the acquisition
- pre-trigger and post-trigger of the acquisition (before or after Start); see chapter
Memory Mode
Real-time Saving: simultaneous recording of the acquisition into a file
- place and name of the saving file
- maximum length of the file
Impossible is displayed when the saving capabilities are overrun: reduce the
sampling rate or the number of channels
See chapter File mode to know the limitations of the file recording
Following: actions after the end of the acquisition
- Save on file: saving the acquisition into a file if the real-time saving is not validated
(or is impossible)
- Plot: plotting the acquisition
- Stop: no action
- Rearm.: waiting for the start condition
- Change Setup: loading a configuration and waiting for the start trigger
10.2.
Creation of the frame
Make a normal acquisition or display a previously recorded file with the function Memory
output .
In the page Trigger , select the parameter Channels for Go/Nogo then Visualize the
frame then Modify .
The appliance will then display the current frame. It appears as 2 curves (a min and a max curve)
around the channel selected as a reference for the frame.