Kramer 4 x 4 Seamless AV Matrix Switcher/Multi-Scaler User Manual
User manual, Vsm-4x4a
Advertising
Table of contents
Document Outline
- 1 Introduction
- 2 Getting Started
- 3 Overview
- 4 Installing in a Rack
- 5 Connecting and Operating the VSM-4x4A
- 6 Controlling the VSM-4x4A
- 6.1 Controlling via the Front Panel Buttons
- 6.2 Using the OSD Menu
- 6.2.1 Configuring the Operation Mode (MODE Menu)
- 6.2.2 Configuring Picture Parameters for each Mode (PICTURE Menu)
- 6.2.3 Configuring Output Parameters (OUTPUT Menu)
- 6.2.4 Configuring EDID for each Input (EDID Menu)
- 6.2.5 Configuring Source Parameters for each Mode (SOURCE Menu)
- 6.2.6 Storing and Recalling Setups (RECALL/STORE Menu)
- 6.2.7 Configuring HDCP for Inputs and Outputs (HDCP Menu)
- 6.2.8 Configuring Analog Audio Level (VOLUME Menu)
- 6.2.9 Configuring Ethernet Parameters (ETHERNET Menu)
- 6.2.10 Configuring OSD Parameters (OSD SETTINGS Menu)
- 6.2.11 Configuring Power Saving Settings (ADVANCED > AUTO SYNC OFF Menu)
- 6.2.12 Configuring Lock Mode (ADVANCED > LOCK MODE Menu)
- 6.2.13 Upgrading Firmware (ADVANCED > FW USB UPGRADE Menu)
- 6.2.14 Resetting to Factory Default Settings (FACTORY DEFAULT Menu)
- 6.2.15 Viewing Device Status (INFORMATION Menu)
- 6.3 Connecting to the VSM-4x4A via RS-232
- 6.4 Operating the VSM-4x4A via Ethernet
- 6.5 Controlling via the IR Remote Control
- 6.6 Using the IR Remote Control in Dual Mode
- 7 Firmware Upgrade
- 8 Using the Embedded Web Pages
- 9 Technical Specifications
- 10 VSM-4x4A RS-232/Ethernet Communication Protocol
- 10.1 Understanding Protocol 3000
- 10.2 Kramer Protocol 3000 Syntax
- 10.3 Protocol 3000 Commands
- 10.3.1 Mandatory System Commands
- 10.3.2 System Commands
- 10.3.3 Switching/Routing Commands
- 10.3.4 Video Commands
- 10.3.5 Audio Commands
- 10.3.6 Communication Commands
- 10.3.7 Multiviewer/Scaler Commands
- 10.3.8 Custom Commands
- 10.3.9 Miscellaneous Commands
- 10.3.10 Input/Output Resolutions Key
- 10.3.11 Error Codes