Kramer 4 x 4 Seamless AV Matrix Switcher/Multi-Scaler - Manual (Page 96)

VSM-4x4A – VSM-4x4A RS-232/Ethernet Communication Protocol 89
10.3.2.12 SIGNAL
Functions Permission Transparency
Set: - - -
Get: SIGNAL? End User Public
Description Syntax
Set: - -
Get: Get input signal lock status # SIGNAL? SPinp_idCR
Response
~nn@ SIGNAL SPinp_id,statusCR LF
Parameters
inp_id – 1 (IN 1), 2 (IN 2), 3 (IN 3), 4 (IN 4), * (All)
status – 0 (Signal is not valid), 1 (Signal is valid)
Notes
After execution, a response is sent to the com port from which the Get was received
A response is sent after every change in input signal status from On to Off or from Off to On
K-Config Example
Get the signal lock status of IN 1:
“#SIGNAL? 1”,0x0D
10.3.3 Switching/Routing Commands
Command Description
ROUTE Set/get layer routing
10.3.3.1 ROUTE
Functions Permission Transparency
Set:
ROUTE
End User -
Get:
ROUTE?
End User Switching
Description Syntax
Set: Set layer routing # ROUTE SPlayer,dest,srcCR
Get: Get layer routing # ROUTE? SPlayer,destCR
Response
~ nn@ ROUTE SPlayer,dest,srcCR LF
Parameters
layer – Layer number: 1 (Video), 2 (Audio for Dual and Quad modes only)
dest – 1 (OUT A), 2 (OUT B), 3 (OUT C), 4 (OUT D), * (All)
src – 1 (IN 1), 2 (IN 2), 3 (IN 3), 4 (IN 4), 5 (Off - not for audio)
Audio for Dual mode:
dest – 1 (OUT A), 2 (OUT B), 3 (OUT C), 4 (OUT D)
src – for dual A: 1 (IN 1), 2 (IN 2); for dual B: 3 (IN 3), 4 (IN 4)
Notes
This command replaces all other routing commands.