Henny Penny OEA/OGA-323 - Manual (Page 38)

Model OFE/OFG-321,322,323,324
3-11. FILTERING 3. Open door(s) under unit, and slowly turn drain
OF SHORTENING valve handle a half turn. Leave for a few minutes, then
(Continued) slowly, fully open drain valve. This prevents much
splashing of the hot shortening as it drains.
4. As the shortening drains from the frypot, use brushes
to clean the sides of the frypot and the burner tubes or
heating elements. If the drain fills with breading, use
straight white brush to push excess breading into the filter
drain pan.
5. When all of the shortening has drained, scrape or brush the
sides and the bottom of the frypot.
6. Rinse the frypot as follows:
Standard 322, 323, & 324 Open fryers
a. Close the drain valve.
DRAIN VALVE HANDLE FILTER VALVE HANDLE b. Position return line over empty frypot.
c. Move the pump switch to the pump position.
d. Fill the frypot 1/3 full, then turn off pump.
e. Wash down and scrub the sides of the frypot with
the brushes.
f. After the sides and bottom are cleaned, open the
drain valve.
321 Open fryers-After April, 2002
a. Close the drain valve. Figure 3-3.
b. Open the filter valve. Figure 3-3.
c. Move the pump switch to the pump position.
d. Fill the frypot 1/3 full, then turn off pump.
e. Wash down and scrub the sides of the frypot with
the brushes.
FILTER UNION FEMALE QUICK- f. After the sides and bottom are cleaned, open the
DISCONNECT drain valve.
Figure 3-3
IF THERE ARE AIR BUBBLES COMING UP
IN THE SHORTENING BEFORE ALL
SHORTENING IS PUMPED UP, IT’S POSSIBLE
THAT THE FILTER CONNECTION AT THE
UNION ON THE FILTER TUBE IS NOT
TIGHTENED PROPERLY. IF SO, TURN
OFF THE PUMP AND WEAR PROTECTIVE
GLOVES OR CLOTH WHEN TIGHTENING
THE UNION. THIS UNION WILL BE HOT.
SEVERE BURNS COULD RESULT.
3-18 703