Henny Penny OEA/OGA-323 User Manual

Page 71

Advertising
background image

Model OFE/OFG-321,322,323,324




6-1. INFORMATION MODE

S = ON/OFF switch “on” interlock circuit: If “S” is

FUNCTIONS (Continued)

present, ON/OFF switch is in the ON position.

If the “S” is missing, the power switch is either off, failed,

or wired incorrectly.

F = FAN (gas fryers)

P = (PILOT VALVE) -- On Gas fryers this signal comes

from the Ignition Module PV output.

M = (MAIN VALVE) – On Gas fryers this signal comes

from the Ignition Module MV output.


Press to view the specific status of each input. An

underscore (“_”) indicates the input is not presently detected.

A Checkmark (“√” ) indicates the signal is detecting a normal

input. A blinking (“X”) indicates the signal is presently

detected, but is detected as a half-wave (partially failed)

input.


The V, H, D, S, F, P and M signals below are wired in

series. The first signal missing out of this sequence l

generally causes all signals to the right of it to be

missing as well.


Press to continue onto OUTP H*.



7. OUTP ELEC: H* GAS: F*I*H

This mode displays the status of components and outputs. If

the output signal is detected, an identifying letter is displayed

(see below), followed by an “*”. If the output is off, “_” is

displayed.

F = Fan output (gas only)

I = Ignition module output (gas only)

H = Heat output


On gas units, if fan is on, “F*” shows in display. If fan is

off, “F_” shows in display. If controls senses a problem with

the fan output, “F*” shows in display, with the “*” flashing.


On gas units, if power is to module, “I*” shows in display. If no

power is to module, “I_” shows in display. If controls senses a

problem with the module output, “I*” shows in display, with the

“*”

flashing.


If heat is on, “H*” shows in display. If heat is off, “H_”

shows in display. If controls sense a problem with the heat

output, “H*” shows in display, with the “*” flashing.


Press to view the amp “DRAW” status of each output. “F √”,

“H √” and “P √” in the display means the amps are good. A

flashing “X” behind the F, H or P means too much current.

1005

6-5

Advertising
This manual is related to the following products: