Henny Penny OEA/OGA-323 - Manual (Page 60)

Model OFE/OFG-321,322,323,324
4-3. SPECIAL PROGRAM 6 Product Controls Only
MODE (Continued)
Enable 2 products Per Button (SP-13)
This mode is an option that allows the operator to be
able to program 2 product times on each button.
a. Follow steps 1 and 2 above.
b. Press the PROG button until “SP-13” and “ENABLE 2
PRODS PER BTN?” show in the display. “YES” or
“NO” shows on the right side of the display.
c. Press and release the UP and DOWN arrows to toggle
between “YES” and “NO”. If “NO” is displayed, only
one product may be programmed per each product
button. If “YES” is displayed, two products may be
programmed per each product button. They will be
displayed as “1A”, “1B”, “2A”, “2B” etc.
12 Product Controls Only
Number of Baskets (SP-13)
This allows the operator to set the controls for use of 1
basket or 2.
a. Follow steps 1 and 2 above.
b. Press PROG until “SP-13” and “NUMBER OF
BASKETS” show in the display.
c. Press the UP or DOWN buttons to toggle between
“1,BSKT”, or “2,BSKT”.
6 Product Controls Only
Active Quality Timers (SP-14)
a. Follow steps 1 and 2 above.
b. Press PROG until “SP-14” and “ACTIVE QUALITY
TIMERS” show in the display. “NORMAL” or
“DUAL” shows on the right side of the display.
c. Press the UP or DOWN buttons to select “NORMAL”
or “DUAL”. “NORMAL” allows only one quality
timer to run at a time. “DUAL” allows 2 quality
timers to run simultaneously.
12 Product Controls Only
Auto-lift Detection (SP-14)
a. Follow steps 1 and 2 above.
b. Press PROG until “SP-14” and “AUTOLIFT” show
in the display.
c. Keep the controls set at “1,DETECT” for the controls
to automatically detect the auto-lift or not.
4-12 1005