HP 250C - Manual (Page 120)

W A R N I N G
Make sure that the carriage
is in the down position at all
times when passing over the
gauge.
Ledge
7Ć12 Calibrations and Adjustments C4699Ć90000
5 Place the gauge on the drive roller on the leftĆhand side of the carriage, with the GO side
facing the carriage, in the position shown below:
Drive Roller
Gauge
Gauge must be parallel to the centerĆline
of the Drive Roller
B
Y
6 With the gauge held in place, manually move the carriage over the GO side of the gauge.
The ledge, indicated below, should easily pass over the GO side of the gauge.
If the ledge does not go over the GO side of the gauge, adjust the carriageĆtoĆmedia
distance ' page 7Ć13.
7 Remove the gauge and replace it on the drive roller with the NO GO side facing the
carriage.
8 With the gauge held in place, manually try to pass the carriage over the NO GO side of
the gauge. The ledge, indicated above, should not pass over the NO GO side of the gauge.
If the ledge does go over the NO GO side of the gauge, adjust the carriageĆtoĆmedia
distance ' page 7Ć13.
9 Replace the Yellow cartridge in the carriage.