HP 250C - Manual (Page 155)

8Ć21 Troubleshooting C4699Ć90000
Filename Failure
(and most frequent causes)
Line Number
Filename Failure
(and most frequent causes) Firmware
A.01.05
Firmware
A.01.04
Firmware
A.01.03
selftest.c 1516 1516 1516 Failure in RAM SIMM test:
D RAM SIMM badly connected.
D Faulty RAM SIMM.
D Faulty electronics module.
selftest.c 1520 1520 1520 Failure in RAM SIMM test:
D RAM SIMM badly connected.
D Faulty RAM SIMM.
D Faulty electronics module.
selftest.c 1563 1563 1563 Failure in Fibis test:
D Faulty electronics module.
selftest.c 1567 1567 - Failure in Fibis RAM sequence test:
D Faulty electronics module.
selftest.c 1573 1573 1573 Failure in Condor test:
D If firmware is revision A.01.02 or
earlier, then change to latest.
D Faulty electronics module.
ipc.c 824 824 824 The SPROC did not respond within
10 seconds:
D Faulty electronics module.
media_load.c 862
or 889
or 993
or 1310
862
or 889
or 993
or 1310
862
or 889
or 993
or 1310
Bail error or YĆaxis servo error:
D Carriage knocked against bail.
D Faulty encoder strip.
D Faulty trailing cable.
D Faulty carriage.
fpmain.c 1489 1489 1489 PCA was initialized in a Designjet
250C and used in a DesignJet 230.
EEROM needs to be reset.
error.c 537 537 537 Processor error:
D Faulty electronics module.