HP 250C User Manual
Page 88
Advertising
6Ć30
Removal and Replacement
C4699Ć90000
7 Remove the engaging lever.
8 Remove the spring from the bailĆgear
assembly.
9 Loosen the screw from the top of the
bailĆgear assembly.
Torx-8
10 Remove the screw from the plastic bail
gear.
You may need to hold the bail cam steady
inside the sideĆplate at the same time. You
can access the cam through the hole
underneath the sideĆplate.
Torx-15
11 Pull the bail gear assemblyout from the
plotter.
The cam falls to the floor of the plotter.
Advertising