HP 250C - Manual (Page 146)

Paper + Error + Fast + Load Media:
Error in XĆaxis encoder quadrature
(media-axis). Possible causes are:
D Incorrect routing of the motor cables.
D Electrical noise in motors. D Faulty motor encoder. D Motor received an
electrostatic discharge while operating.
Paper + Cartridges + Error + Film + Fast:
CartridgeĆalignment firmware error.
Try one or more of the following:
D Turn the plotter off, and then on again to see if the problem disappears.
D Ensure that the cartridges are correctly seated. D Replace cartridges.
D If the problem remains, consult recent service notes for a possible solution.
D If no service note deals with this error, report the problem to your HP
Response Center. Note conditions and actions before error occurred. Include
setup sheet and service configuration plot in report.
Paper + Error + Film + Fast + Load Media:
Error in bailĆlift mechanism. The
bailĆlift system is unable to raise or lower the bail. (It is the carriage that
tests to see whether the bail is in the correct position by trying to knock
against it.)
D Check the bailĆlift system to see if it is working correctly. D Use the bail
cycle test to help troubleshoot.
For more precise troubleshooting ' page 8Ć19, w System Errors.
Error + Film + Fast + Load Media:
Error in encoderĆstrip quadrature (carriage
axis). Possible causes are:
D Incorrect routing of the motor cables.
D Trailing cable is faulty or badly connected. D Faulty carriage.
D Motor received an electrostatic discharge while operating.
Steady 1356
Steady 12345
Steady 13456
Steady 3456
Paper + Error + Fast + Special:
Contents of the EEROM have been lost.
D Perform the electrical test. If it fails, the main PCA is faulty.
D Don't rule out the fact that any new service test that you perform may
corrupt the EEROM.
For more information ' page 8Ć27, w EEROM Errors.
Steady 1357
Paper + Error + Film + Ready:
Failure of centronics READ.
Firmware error or faulty electronics module.
Steady 1349
8Ć12 Troubleshooting C4699Ć90000