Fuji Bikes FRENIC 5000G11S/P11S - Manual (Page 46)

4-14
Inverter type of data
stored in the keypad
panel
60.00
60.00
1.DATA SETTING
2.DATA CHECK
3.OPR MNTR
4.I/O CHECK
5.MAINTENANC
6.LOAD FCTR
7.ALM INF
8.ALM CAUSE
⇒9.DATA COPY
Error processing
Data check
(verify)
<DATA COPY>
040HP-4
READ
<DATA COPY>
040HP-4
VERIFY
Mode (data check)
<DATA COPY>
040HP-4
VERIFY
„„„„ Data check in progress
<DATA COPY>
040HP-4
WRITE
INV RUNNING
RUN
PRG ⇒PRG
MENU
F/D
⇒LED SHIFT
<DATA COPY>
040HP-4
VERIFY
COMPLETE
„„„„„„„„„„„„„„„
Data check complete
<DATA COPY>
040HP-4
WRITE
1) Change disabled during operation
If a write operation is attempted during an inverter
operation, or vice versa, the error message below will
appear.
After stopping the inverter and pressing , retry the
write operation.
2) Memory error
If a write operation is attempted while data has not been
saved (i.e., no data) in the keypad panel data memory
during the read mode, the following error message will
appear:
<DATA COPY>
WRITE
MEMORY ERROR
3) Verify error
During a data check (verify) operation, if data stored in
the keypad panel differs from data stored in the inverter,
the following error message is displayed to indicate the
function No. The data check is suspended.
To continue the data check and check for other
mismatching data, press . To stop the data check
and switch to another operation, press .
<DATA COPY>
075HP-4
WRITE
ERR:F25
„„„„
4) Data protection
When WRITE to the inverter which is protected by
"Data protection" function, the following error message
will appear. After released the protection, write
operation is attempted.
<DATA COPY>
040HP-4
WRITE
DATA PRTCTD
FUNC
DATA
FUNC
DATA
FUNC
DATA
RESET
PRG
∧
∧
RESET