Fostex DV824 - Manual (Page 131)

131
DVD Multitrack Recorder DV824 DVD Multitrack Recorder DV824 DVD Multitrack Recorder DV824 DVD Multitrack Recorder DV824 DVD Multitrack Recorder DV824
Using the "Sel. TC Out" menu item, you can set the time code source (Repro or Gen) fed from
the [TIME CODE OUT] connector.
<Note>: The "Sel. TC Out" menu item setting is effective only when the optional TC/
SYNC card is installed. When it is not installed, "Void! No TC Card" is shown and you
cannot make setting.
<Note>: Even if "Sel. TC Out" is set to "Gen", the generator time code is not output
when the generator mode is set to the "EXT RUN" mode.
Repro
Gen Outputs the internal generator time code.
Outputs playback time code. This is the default.
Time code output source selection [Sel. TC Out]
Options Details
Using the "Default LTC start" menu item, you can set the desired default LTC start time value
(the initial setting is "1h 00m 00s"). This value is used when the generator mode is set to "Ext
Run" but no external time code is fed to the unit.
1) Select the "Default LTC start" menu item and press the [ENTER/YES key.
The current LTC start time is shown (initially, "1h 00m 00s" is shown).
2) Press the [ENTER/YES] key again.
The second value flashes and you can now edit the default LTC start time.
<Note>: The unit does not recognize paused time code as "correct" time code. It
recognizes time code when receiving more than two continuous frames.
Default LTC start time setting [Default LTC start]
Use the [MENU] dial to select the desired option, and press the [ENTER/YES] key to confirm
your setting. Press the [STOP/HOME] key to exit the MENU mode.
Select the "Sel. TC Out" menu item and press the [ENTER/YES] key.
The current setting starts flashing and you can now select the desired option.