Fostex DV824 - Manual (Page 85)

85
DVD Multitrack Recorder DV824 DVD Multitrack Recorder DV824 DVD Multitrack Recorder DV824 DVD Multitrack Recorder DV824 DVD Multitrack Recorder DV824
Making auto copy
2) Press the [RECORD] key to start recording to the partition.
When the auto copy mode is set to "IMME", audio data is recorded to the
partition, while it is copied to the DV824 DVD-RAM disk.
3) Press the [STOP/HOME] key to stop recording.
If you choose the "BGRD" (Background mode) in step 4) and execute recording,
auto copy actually starts when pressing the [STOP/HOME] key to stop recording.
When starting auto copy, "Backup Copy start!" is shown on the display for a few
seconds, and immediately after auto copy finishes, "Backup Copy Finished!" is shown.
In the "BGRD" (background) mode, even if no DVD-RAM disk is set, the DV824
makes recording to the partition. In such a case, the copy data remains internally
after recording to the partition finishes, therefore, auto copy is executed when set-
ting a blank DVD-RAM disk.
<Note>: If you execute auto copy without setting a copy destination (blank DVD-
RAM) disk, the copy data remains until turning off the unit. however, once you
turn off the unit, the copy data is erased and the unit does not execute auto
copy.
<Note>: If you do not need to make auto copy, set the "Auto copy" menu item back to
"Off".
BKUP **h**m**s
SAFE/RDY
9
WXYZ
1) Press the [SAFE/RDY] key to make the unit record ready (the [SAFE/RDY]
indicator flashes).
By making the unit record ready while the auto copy mode is active, the copy
source (partition) remaining time and copy destination (DVD-RAM disk)
remaining time is alternately shown.