Fostex DV824 - Manual (Page 21)

21
DVD Multitrack Recorder DV824 DVD Multitrack Recorder DV824 DVD Multitrack Recorder DV824 DVD Multitrack Recorder DV824 DVD Multitrack Recorder DV824
3) Press the [EXIT/NO] key (or the [STOP/HOME] key) to exit the MENU mode.
The display now shows the Home screen on which " -No files!- " is shown.
Naturally, there is no files on a disk immediately after it is formatted.
Now UDF-formatting of the supplied DVD-RAM disk completed and you can make
recording and playback of the disk.
You can format a DVD-RAM disk you purchase in the same manner as above.
<Note>: To reformat a formatted DVD-RAM disk or to physically format a well-
used disk, see "Formatting a disk" on page 149.
2) Press the [ENTER/YES] key again.
The unit starts formatting the disk.
The display shows the formatting countdown, as well as the progress status by the
bar-graph meter.
When formatting completes, the display shows "
Fmt. Completed! " and the unit
stops disk access.
1) Use the [MENU] dial to select "[EXECUTE]" and press the [ENTER/YES] key.
The display changes to show the warning message (i.e. all disk data are gone by
formatting the disk) and flashing "
Are you sure? ".
The following description shows how to UDF-format an unused 4.7GB/Type2 DVD-
RAM disk which is supplied with the unit, leaving the four items above as their de-
fault settings.
<Note>: Note that the formatting countdown and bar-graph meter show the
approximate information. Do not proceed to the next step before " Fmt. Com-
pleted! " is shown.