Fostex DV824 - Manual (Page 46)

46
DVD Multitrack Recorder DV824 DVD Multitrack Recorder DV824 DVD Multitrack Recorder DV824 DVD Multitrack Recorder DV824 DVD Multitrack Recorder DV824
TC frame rate selection (" FRAME " of the status information area)
You can select the frame rate of LTC recorded together with audio (or time code re-
corded when the optional TC/SYNC card is installed).
By selecting "
FRAME
" and pressing the [ENTER/YES] key, you can select the desired frame
rate from among the following (the default is "25").
The unit records LTC together with audio signals. By default, "01h00m00s00f" is stamped
at the beginning (one-hour offset to ABS) and the generator records LTC jammed to this
start time code. The LTC recording mode ("TC GEN" mode) is set to "Rec Run" by de-
fault, so each time you make audio recording, continuous LTC is recorded.
You can also set the time code frame rate via the "Frame rate" menu item in the "TC
SETUP" menu of the MENU mode (
see page 127 for details ). You also can edit the LTC start
time via the "Default LTC Start" menu item in the "TC SETUP" menu of the MENU mode
(
see page 131 for details ).
23.97
24
25
29.97DF
29.97ND
30
30DF
American motion picture -0.1%
American motion picture
European film/PAL-SECAM video EBU
NTSC color with real time adjust
NTSC color
NTSC video/film
NTSC video/film
<Note>: The INPUT section in the status information area shows as below de-
pending on the selection between "Analog" and "Digital".
When selecting
"Analog"
When selecting
"Digital"
The left screen example shows when “Analog” is selected
here. All channels (1 through 8) can record analog audio
signals, regardless of the “Setup digital in” setting in the
“SYS SETUP” menu.
The left screen example shows when “Digital” is selected
here. All channels (1 through 8) lock to digital input sig-
nals and can record them. In this example, the “Setup
digital in” setting in the “SYS SETUP” menu is the default
(i.e. all channels are set to “Digital”).
If a channel does not lock to the digital input signal, it
automatically switches to select analog input, while the
corresponding channel number and “Digital” flash quickly
for warning.
The left screen example shows when “Analog” is selected
here, however, the “Setup digital in” setting in the “SYS
SETUP” menu is as below.
• channels 1-2: “Analog”
• channels 3-4, 5-6 and 7-8: “Digital”
In this case, you can record analog and digital signals
together. If a channel does not lock to the digital input
signal, it automatically switches to select analog input,
while the corresponding channel number and “Digital”
flash quickly for warning.
When selecting
"Digital"