Freescale Semiconductor Target Interface MMDS0508 - Manual (Page 20)

Con nector Info rmat ion
Power Supply Fuse Replacement
3–20 MMDS0508 Target Interface
• Pod B pin 17 is the external timetag input for the bus state analyzer. To use this
source, make the desired clock connection to the white probe tip, then use the
TIMETAG command to select an external time tag source for the analyzer.
3.5 Power Supply Fuse Replacement
The station module power switch/connector assembly contains a standard 1/4 x 1 1/4
inch, 1.6-ampere, 250-volt ceramic, time-delay fuse.
Figure 3.2 shows this assembly
with its door open (for fuse replacement).
Figure 3.2 Power Switch/Connector Assembly
Figure 1. Power Switch/Connector Assembly
To replace the fuse, follow these steps:
1. Press the power switch OFF and disconnect the power cord.
Power Cord Socket
Fuse Door
Fuse
Power Switch
Tab
Freescale Semiconductor, Inc.
For More Information: www.freescale.com