Freescale Semiconductor Target Interface MMDS0508 - Manual (Page 21)

Connector Informatio n
Power Supply Fuse Replacement
3–21 MMDS0508 Target Interface
2. Insert a small screwdriver at the tab on the right edge of the switch/connector assembly.
(Figure 1 shows where to insert the screwdriver.) Gently pry open the assembly door,
which swings open to the left.
3. Remove the fuse holder from the switch/connector assembly. Remove the fuse from the
holder.
4. Insert the replacement fuse into the holder. Then re-install the holder in the switch/
connector assembly. Make sure that the fuse holder arrow points down. Close the
assembly door.
5. Reconnect the power cord. This completes fuse replacement.
Freescale Semiconductor, Inc.
For More Information: www.freescale.com