Freescale Semiconductor Target Interface MMDS0508 - Manual (Page 59)

A–59 MMDS0508 Target Interface
A
Appendix
A.1 MMDS Commands
This section describes MMDS-specific commands.
Use MMDS-specific commands as you would any other commands, typing them in
the Command Line component, or inserting them into a command file.
For further details about debugger commands, please see the debugger manual
sections Appendix, Debugger Commands and Command Line Component.
A.1.1 Baud Rate Command
BAUD
A.1.1.1 Short Description
sets the communication baud rate.
A.1.1.2 Syntax
BAUD [rate]
rate
: Specifies the new baud rate; must be one of these decimal integer constants:
1200, 2400, 4800, 9600, 19200, 28800, 38400, 57600, 115200.
A.1.1.3 Description
The BAUD command sets or displays the baud rate for communication between the
system controller and the host computer. For maximum performance, the baud rate
should be as high as the host computer can accommodate. The maximum rate is
115200; the default baud rate is 9600.
Freescale Semiconductor, Inc.
For More Information: www.freescale.com