Freescale Semiconductor Target Interface MMDS0508 - Manual (Page 28)

MMDS Target Componen t
4.6 Communication Configuration
4–28 MMDS0508 Target Interface
Figure 4.6 MotoSIL Communication Configuration
Make sure that host-computer parameter values are correct; make sure that the serial-
communication setting is correct. Otherwise, communication between the debugger
and the target is not possible.
4.6.1 Communication Device Specification
If the host and target are not connected, or if the communication device is not properly
indicated, the Communications Device Specification dialog box appears as shown in
Figure 4.7 :
Figure 4.7 Communication Device Specification
Type the name of an available communication device in the Communication Device
edit box, use the drop-down control to set the baud rate, then click Connect. (The
default communication device is COM1.)
Once connection succeeds, the debugger saves the settings as defaults for later debug
sessions. Should the connection fail, a message box so informs you, so that you can
define a new communication device. To quit the dialog box and the environment, click
Cancel.
Freescale Semiconductor, Inc.
For More Information: www.freescale.com