Frymaster BIGLA30 - Manual (Page 22)

3-4
adjust the position of the plate to open or close the air intake opening until a bright orange-red glow
is obtained. Carefully hold the plate in position and tighten the locking nut.
3.1.3 Shutdown
For short-term shut down during the workday:
1. Place the computer ON/OFF switch in the OFF position and put the frypot covers in place.
When shutting the fryers down at closing time:
1. Place the computer ON/OFF switch in the OFF position to turn the fryer off.
For Non-CE Fryers
After placing the ON/OFF switch in the OFF
position, turn the gas valve knob to the OFF
position.
Hone
yw
el
l
ON
OF
F
Hone
yw
el
l
ON
OF
F
For CE Fryers
Placing the ON/OFF switch in the OFF
position also turns off the gas valve.
2. Filter the oil and clean the fryers (See Chapters 5 and 6).
3. Place the frypot covers on the frypots.
3.2 Operation
This fryer is equipped with M3000 computers (illustrated below). Refer to the M3000 Computer
Operating Instructions in Chapter 4 for the computer programming and operating procedures.
M3000 COMPUTER
Refer to Chapter 5 of this manual for operating instructions for the built-in filtration system.