Frymaster BIGLA30 - Manual (Page 65)

5-3
If the oil level is too low, the computer displays OIL LEVEL TOO LOW alternating with
YES. Press 9 (1) YES to acknowledge issue and return to idle cook mode. Check to see if the
JIB is low on oil. If JIB is not low and this continues to occur, contact your ASA.
If YES is chosen, SKIM VAT is displayed for ten seconds changing to cOnfIRm alternating
with YES NO. Skim the crumbs from the oil with a front to back motion, removing as many
crumbs as possible from each vat. This is critical to optimizing usable oil life and quality in the oil.
Note: If
NO is chosen in response to either FILTER now or CONFIRM, filtering is
cancelled and the fryer resumes normal operation. The FILTER now prompt is
displayed once the FILTER AFTER count is satisfied. This sequence repeats until yes is
chosen.
If the filter pan is not fully engaged, the computer displays INSERT PAN. Once the filter pan is
pushed fully into place, the computer displays SKIM VAT.
2. When 9 (1) YES is chosen, the auto filtration cycle is started. The fryer displays
DRAINING, WASHING and FILLING during the process.
Note: Simultaneous filtering of multiple vats does not occur.
Once filtering is complete the computer display changes to low temp until the fryer reaches
setpoint.
Once fryer reaches setpoint and the computer display changes to the product name or dashed lines,
the fryer is ready for use.
The complete filtering process takes roughly four minutes.
NOTE: If during filtration the filter pan is pulled, the filtration process stops and resumes once pan
is reseated into place.
DANGER
Keep all items out of drains. Closing actuators may cause damage or injury.
5.3.1 Auto Demand Filtration
Auto demand filtration is used to manually start an auto filtration.
1. The fryer MUST be at setpoint temperature.
With the computer on press and hold the
FLTR button for three seconds.
The computer displays fIltEr menu for three seconds changing to Auto Filter.