Freescale Semiconductor MC68HC908MR32 - Manual (Page 177)

I/O Registers
MC68HC908MR32 • MC68HC908MR16 Data Sheet, Rev. 6.1
Freescale Semiconductor 177
RPF —Reception-in-Progress Flag
This read-only bit is set when the receiver detects a logic 0 during the RT1 time period of the start bit
search. RPF does not generate an interrupt request. RPF is reset after the receiver detects false start
bits (usually from noise or a baud rate mismatch, or when the receiver detects an idle character. Polling
RPF before disabling the SCI module or entering stop mode can show whether a reception is in
progress.
1 = Reception in progress
0 = No reception in progress
13.7.6 SCI Data Register
The SCI data register (SCDR) is the buffer between the internal data bus and the receive and transmit
shift registers. Reset has no effect on data in the SCI data register.
R7/T7:R0/T0 — Receive/Transmit Data Bits
Reading address $003D accesses the read-only received data bits, R7:R0. Writing to address $003D
writes the data to be transmitted, T7:T0. Reset has no effect on the SCI data register.
13.7.7 SCI Baud Rate Register
The baud rate register (SCBR) selects the baud rate for both the receiver and the transmitter.
SCP1 and SCP0 — SCI Baud Rate Prescaler Bits
These read/write bits select the baud rate prescaler divisor as shown in Table 13-5 . Reset clears SCP1
and SCP0.
Address: $003D
Bit 7 6 5 4 3 2 1 Bit 0
Read: R7 R6 R5 R4 R3 R2 R1 R0
Write: T7 T6 T5 T4 T3 T2 T1 T0
Reset: Unaffected by reset
Figure 13-14. SCI Data Register (SCDR)
Address: $003E
Bit 7 6 5 4 3 2 1 Bit 0
Read: 0 0
SCP1 SCP0
0
SCR2 SCR1 SCR0
Write: R R R
Reset: 0 0 0 0 0 0 0 0
R = Reserved
Figure 13-15. SCI Baud Rate Register (SCBR)
Table 13-5. SCI Baud Rate Prescaling
SCP1:SCP0 Prescaler Divisor (PD)
00 1
01 3
10 4
11 13