FUJITSU PRIMERGY MX130 S2 - Manual (Page 133)

MX130 S2 Upgrade and Maintenance Manual 133
HDDs and accessible drives
7.18 Removing backup drive out of 5.25-inch
chassis bay
7.18.1 Required tools
●
Preliminary and concluding steps: tool-less
●
Removing a backup drive: tool-less
7.18.2 Preliminary steps
Before removing a backup drive, perform the following steps:
Ê
Disable BitLocker functionality as described in section "Disabling BitLocker
functionality" on page 59 .
Ê
Remove all backup and optical disk media from backup and optical disk
drives as described in section
"Removing backup and optical disk media" on
page 60 .
Ê
Verify if your backup software solution requires preparative configuration
before starting the procedure as described in section
"Verifying and
configuring the backup software solution" on page 61 .
Ê
Follow all procedures described in section "Opening the server" on page 48 .
Ê
Open the front cage as described in section "Opening the front cage" on
page 52 .
Ê
Locate the correct drive bay as described in section "Mounting order" on
page 82 .