4 connecting cable of the esata cable to connector, 5 concluding steps, 4 removing esata cable – FUJITSU PRIMERGY MX130 S2 User Manual
Page 170: Connecting cable of the esata cable to connector, Concluding steps, Removing esata cable
Advertising
170
Upgrade and Maintenance Manual
MX130
S2
Expansion cards
9.2.3.4
Connecting cable of the eSATA cable to connector
Figure 104: Connecting the eSATA cable
Ê
Connect the end of eSATA cable to the system board connector SATA6.
Ê
Fold the cable carefully as shown in the picture.
9.2.3.5
Concluding steps
Perform the following procedures to complete the task:
Ê
Follow all procedures described in section
"Closing the server" on page 54
.
9.2.4
Removing eSATA cable
Upgrade and Repair Units (URU)
Average task duration: 5 minutes
Advertising