FUJITSU PRIMERGY MX130 S2 - Manual (Page 219)

MX130 S2 Upgrade and Maintenance Manual 219
System board and components
Figure 139: Installing the system board (A)
Ê
Hold the new system board by the memory module ejectors and a PCI slot.
V
CAUTION!
– Do not lift or handle the system board by any of its heat sinks!
– Ensure not to damage the EMI springs to comply with applicable
EMC regulations and satisfy cooling requirements and fire
protection measures.
– Ensure that the system board is not scratched by the metal stop
angle (see circle).
Ê
At a slight angle, lower the system board into the chassis.
Ê
Carefully shift the system board towards the server rear until the plug shells
engage with the cut-outs in the connector panel.
Ê
Lower the system board.