FUJITSU PRIMERGY MX130 S2 - Manual (Page 185)

MX130 S2 Upgrade and Maintenance Manual 185
Main memory
Figure 116: Removing memory modules
Ê
Eject the desired memory module by pressing out the securing clips at each
end of the memory module connector.
Ê
Remove the ejected memory module.
10.3.4 Concluding steps
Perform the following procedures to complete the task:
Ê
Follow all procedures described in section "Closing the server" on page 54 .
Ê
If available, update the system board BIOS to the latest version as described
in section
"Updating the system board BIOS" on page 62 .
Ê
If BitLocker functionality is used and has been disabled before starting the
maintenance task, re-enable BitLocker as described in section
"Enabling
BitLocker functionality" on page 66 .