FUJITSU PRIMERGY MX130 S2 - Manual (Page 183)

MX130 S2 Upgrade and Maintenance Manual 183
Main memory
Figure 115: Installing memory modules (B)
Ê
Align the notch on the bottom of the module with the crossbar in the
connector.
Ê
Press down on the memory module until the securing clips snap into the
cutouts at each end of the module.
10.2.4 Concluding steps
Perform the following procedures to complete the task:
Ê
Follow all procedures described in section "Closing the server" on page 54 .
Ê
If available, update the system board BIOS to the latest version as described
in section
"Updating the system board BIOS" on page 62 .
Ê
If BitLocker functionality is used and has been disabled before starting the
maintenance task, re-enable BitLocker as described in section
"Enabling
BitLocker functionality" on page 66 .