FUJITSU PRIMERGY MX130 S2 - Manual (Page 48)

48 Upgrade and Maintenance Manual MX130 S2
Basic hardware procedures
4.2 Opening the server
V
CAUTION!
●
Before removing or installing covers, turn off the server and all
peripheral devices. Also unplug all power cables from the outlet.
Failure to do so can cause electric shock.
●
In order to comply with applicable EMC regulations (regulations on
electromagnetic compatibility) and satisfy cooling requirements, the
PRIMERGY MX130 S2 server must not run while the server cover is
removed.
●
For further safety information, please refer to chapter "Important
information" on page 31 .
4.2.1 Shutting down the server
V
CAUTION!
For further safety information, please refer to chapter "Important
information" on page 31 .
I
This step is only required when upgrading or replacing non-hot plug
components.
Ê
Inform the system administrator that the server will be shut down and put
offline.
Ê
Terminate all applications.
Ê
Verify if your backup software solution requires preparative configuration
before starting the procedure as described in section
"Verifying and
configuring the backup software solution" on page 61 .
Ê
Remove all backup and optical disk media from backup and optical disk
drives as described in section
"Removing backup and optical disk media" on
page 60 .