Genicom GEK 00031B - Manual (Page 135)

GEK-00029A 5000 Series Programmer’s Manual 135
CHARACTER SPACING
ESC SI Select Condensed Print Mode: Performs the same function as the SI
control code.
Decimal: 27 15
Hex: 1B 0F
BASIC: CHR$(27);CHR$(15);
ESC M Select Elite Pitch: This sets the pitch to 12 cpi.
Decimal:
27 77
Hex: 1B 4D
BASIC: CHR$(27);”M”;
ESC P Select Pica Pitch: This sets the pitch to 10 cpi.
Decimal:
27 80
Hex: 1B 50
BASIC: CHR$(27);”P”;
ESC p n Turn Proportional Mode On/Off: Turns the proportional print mode
on or off according to the value of n.
n Effect
l Unidirectional printing on
0 Unidirectional printing off
This command overrides the condensed print mode.
Decimal: 27 74 n
Hex: 1B 4A nH
BASIC: CHR$(27);"J";CHR$(n);
ESC SP n Set Intercharacter Spacing: Sets the amount of space added to each
character in increments of 1/120-inch. This space is added to the
space already allocated in the character’s design. Parameter limits
are 0-63 (decimal).
Decimal: 27 32 n
Hex: 1B 20 n
BASIC: CHR$(27);CHR$(32);CHR$(n);