Genicom GEK 00031B - Manual (Page 213)

GEK-00029B 5000 Series Programmer’s Manual 213
DECAUPSS Assign User Preference Supplemental Set: Assigns a particular
character set to the User Preference Supplemental set. This becomes
the character set designated by the User Preference character set
final when used in a Select Character Set (SCS) sequence.
Source: Print manager
Destination: Levels 1, 2, 3
Format
DCS Ps U D ... D ST
Description
Ps indicates whether the User Preference set is a 94-character or a
96-character set:
Ps Meaning
0 94-character set
1 96-character set
D ... D is a string containing the intermediate and final characters of
the designating sequence used to explicitly select the supplemental
character set. See SCS in this chapter for a list of intermediate and
final characters.
To assign DEC Supplemental as the User Preference character set,
use the following DECAUPSS command:
DCS 0 ! u %5 ST
To assign ISO Latin-1 Supplemental as the User Preference set, use
the following DECAUPSS command:
DCS 1 ! u A ST
To use the User Preference set, see User Preference under SCS.
The supported character sets are as follows:
▪ DEC Supplemental (Ps must equal 0)
▪ ISO Latin-1 Supplemental (Ps must equal 1)
▪ DEC Hebrew Supplemental (Ps must equal 0)
▪ ISO Latin-Hebrew Supplemental (Ps must equal 1)
▪ DEC Technical (Ps must equal 0)
▪ Hebrew 7-bit (Ps must equal 0)