Genicom GEK 00031B - Manual (Page 211)

GEK-00029B 5000 Series Programmer’s Manual 211
DAR Printer Attributes Report (generic response): Response to a Print
manager request for a Printer Attributes (DA) report.
Source: Printer
Destination: Print manager
Format
CSI ? Ps1 Ps2 … Psn c
Description
The printer sends this command when set to the generic response.
The printer may be set to use the alias response. See DAR (alias
response) in this chapter.
Ps1 = 73
Ps2-Psn describe the implemented extensions to the protocol. See the
introduction to this chapter for an explanation of extensions. The
following table contains a list of possible extensions.
Parameter
Hex Decimal Protocol Extension
34 4 Sixel graphics
35 5 Katakana character set
36 6 Reserved
38 8 Reserved
39 9 Variable page format select
31 30 10 Text ruling vector drawing
31 31 11 Reserved
31 32 12 Hebrew character sets
The reply to the DA request is sent to the host only after all preceding
data (except DSR) has been processed and printed. This provides a
way for host software to determine when all preceding data has been
successfully printed.
When values are not returned, they are left out of the response
entirely (that is, there are not any blanks indicated by semicolons).
However, software should always accept blank parameters.
The printer sends parameters in ascending order. However, software
should accept the parameters in any order.