Genicom GEK 00031B - Manual (Page 179)

GEK-00029A 5000 Series Programmer’s Manual 179
RIS Reset to Initial State: Resets the value or state of several operating
features. This sequence resets the printer to a set of operating values
and conditions similar to the factory default settings (see table
below).
General Command Syntax
ESC c
Decimal: 27 75
Hex : 1B 63
BASIC: CHR$(27);”c”;
Selectable Parameter Reset Condition
Printing Status On-line
Horizontal Pitch 10 characters per inch
Vertical Pitch 6 lines per inch
Font Data Processing
Forms Length 66 lines (11 inches)
Active position Column 1 on the current line
Top Margin Line 1
Bottom Margin Line 66
Left Margin Column 1
Right Margin Column 136
Underlining Disabled
Bolding Disabled
Italics Disabled
Double Underline Disabled
Overline Disabled
Expansion No character expansion
GL Character Set US ASCII
GR Character Set Digital Supplemental
G0 US ASCII
G1 VT100 Graphic Character Set
G2 Digital Supplemental
G3 US ASCII
Autowrap Disabled
Line Feed/New Line
Mode Reset
Horizontal Tabs Every 8 columns (9,17 …)
Unsolicited Reports Disabled
Super/Subscripts Disabled
Carriage Return/New
line
Reset
Vertical Tabs Every line (1-66)
NOTE
This sequence and the DECSTR reset sequence have the same
function.