Genicom GEK 00031B - Manual (Page 49)

GEK-00029B 5000 Series Programmer’s Manual 49
p9 Bar code rotation and human-readable line (HRL) font style (if
used).
0 No rotation - use currently selected font style, cpi, and
lpi. This is the default setting.
1 No rotation - use special HRL font.
2 90-degree rotation use special HRL font
3 180-degree rotation use special FIRL font.
4 270-degree rotation use special HRL font.
p 10 Horizontal print density
0 60 dpi horizontal by 144 dpi vertical print density
1 120 dpi horizontal by 144 dpi vertical print density
Default for bar code styles 5, 6, 13, and 14 is 120 dpi.
Default for all other styles is 60 dpi.
Bar codes printed at 90 or 270 degrees rotation will print at the same
speed (120 x 144) regardless of the selected horizontal density.
A missing parameter will leave the corresponding value unchanged.
A zero parameter value for p2–p8 will cause the default value to be
selected.
Use semicolons as place holders when changing parameters.
LPRINT CHR$(27);"[;;;;;;;;;1}" Changes only parameter 10.
LPRINT CHR$(27);"15;;0}" Changes only parameters 1 and 3.
LPRINT CHR$(27);"[16}" Changes only the style of the bar code.
If no changes are made to the parameters of the bar code, the printer
will use the following factory-set values.
IMPORTANT
If no parameters have previously been entered, then the
factory default values will be used. If previous values have
been sent from the host, these values will prevail until
changed by the host or the printer is initialized.