Genicom GEK 00031B User Manual
Page 147
GEK-00029A
5000 Series Programmer’s Manual
147
ESC t n
Select a Code Page: Selects one of four variables that contains a
specific code page selection. The four variables are loaded via the
ESC ( t and the ESC [T sequences. The four variables are identified as
0,1,2. and 3 (either binary or ASCII values). This command overrides
the condition set by the CCU menu . Note that italics print can be
selected by using the ESC 4 command even if the eight bit code page
table has been selected.
The four selection variables have the following defaults:
n
Effect
0
No code page (italics 0-128 in upper table
1
USA code page 437
2
No code page (italics 0-128 in upper table
3
USA code page 437
Decimal:
27 116 <n>
Hex:
1 B 74 <n>
BASIC:
CHR$(27);"t<n>";
ESC ( t, n1 n2
Assign a Code Page to One of Four Variables (0, 1, 2, or 3):
m1 m2 m3
Assigns a specific code page to one of the four selection variables
used by the ESC t sequence (either the binary or ASCII value can be
used for ml). Listed below are the values for m2 and m3 required to
assign specific code pages to the select variable ml.
Note that this sequence is similar to the ESC ( T sequence except that
fewer code page choices are available. Also when using this
command, assignments can be made to any of the four different
select variables used by the ESC t sequence.
Hex Values
m2
m3
Character Table
x00
x00
Italic (0-127)
x01
x00
PC 437 (USA)
x03
x00
PC 850 (Multilingual)
x05
x00
PC 853 (Turkish)
x06
x00
PC 855 (Cyrillic)
x07
x00
PC 860 (Portuguese)
x08
x00
PC 863 (Canada-French)
x09
x00
PC 865 (Norway)
x0A
x00
PC 852 (East Europe)
x0B
x00
PC 867 (Turkish)
x0D
x00
PC 864 (Arabic)
x0E
x00
PC 866 (Russian)
x0F
x00
PC 869 (Greek)
x10
x00
USSR GOST (Russian)
x01
x10
PC 437 (Greek
x2C
x00
858
x1D
x0F
8859-15
Some code pages might not be available in all font sets. If the
sequence specifies a code page that is not currently installed, the
sequence is ignored.
Decimal:
27 40 116 3 0 m1 m2 m3
Hex:
1B 28 74 3 0 m1H m2H m3H
BASIC:
CHR$(27);"[t";CHR$(3);CHR$(0);CHR$(m1)
CHR$(m2);CHR$(m3);