Genicom GEK 00031B - Manual (Page 225)

GEK-00029B 5000 Series Programmer’s Manual 225
DECSTBM (continued)
Notes to Software
Margins can be changed or reset as a side effect of other actions.
Also, changing the origin with DECOPM changes the locations of the
top and bottom margins with respect to the paper
DECSTBM should be used only on a new page.
DECSTR Soft Terminal Reset: Resets the initial state values in the printer.
Also returns to DEC PPL3 regardless of the power-up protocol
selected.
Source: Application, Print manager Destination: Levels 1, 2, 3
Format
CSI Pn p Pn (if present) must be 0.
Description
DECSTR is processed synchronously with the rest of the data stream.
The printer sets all the Initial State Values listed in the Programming
Supplement to the "DECSTR" conditions.
The printer does not run self-test, change the current communication
settings, or clear the input buffer.
Side Effects
DECSTR resets Printer Status Report (DSR) events, including
communication failure and input buffer overflow.
The printer performs a conditional Form Feed.
DECSTR affects justification. See Justify (JFY).
See Select Other Coding System (SOCS) when an alternate protocol is
in use.
Error Handling
Any parameters received with DECSTR are ignored.
DECSTR Soft Terminal Reset
Notes to Software
It is recommended that you send this command with no parameter.
Although the DEC PPL3 parsing rules allow a parameter in any
sequence, this sequence is traditionally sent without one. Older
Digital printers may not accept the 0 parameter.