Preparations, Power supply, Using a battery pack – Sony PMW-F3K User Manual

Page 22

Advertising
background image

Power Supply

22

P

repa

ra

ti

ons

You can use a battery pack or AC power via an
AC adaptor.
If you connect an AC power source, it has a
priority even if a battery pack is mounted.

For safety, use only the Sony battery pack and AC
adaptor listed below:
• BP-U60 Lithium-ion Battery Pack
• AC-DN10 AC Adaptor

Mount a BP-U60 Lithium-ion Battery Pack.

Batteries shall not be exposed to excessive heat
such as sunshine, fire or the like.

Danger of explosion if battery is incorrectly
replaced. Replace only with the same or
equivalent type recommended by the
manufacturer.
When you dispose of the battery, you must obey
the law in the relative area or country.

Notes

• Before use, charge the battery pack with the

exclusive BC-U1/U2 Battery Charger.

• A warm battery pack immediately after use may

not be able to be fully recharged.

Mounting the battery pack

Fully insert the battery pack then slide it down to
lock.

Note

If a battery pack that cannot be used with this
camcorder is mounted, an error message is
appears on the LCD monitor/viewfinder screen.
Replace the battery pack with the BP-U60, or
connect a power to the DC IN connector after
removing the battery pack.

Removing the battery pack

Hold the BATTERY RELEASE button pressed,
slide the battery pack upwards to unlock, then
pull it out.

Checking battery charge remaining

To check during operation
When recording or playback is in progress on the
battery pack, an icon to show the current battery

Preparations

Power Supply

Using a Battery Pack

WARNING

CAUTION

Power switch: OFF

Battery pack

2

1

Power switch: OFF

BATTERY RELEASE button

Advertising
This manual is related to the following products: