Attaching the microphone, Using the supplied microphone, Prepa ra ti ons – Sony PMW-F3K User Manual

Page 31

Advertising
background image

Attaching the Microphone

31

P

repa

ra

ti

ons

Two channels (CH-1/CH-2) of audio can be
recorded (Linear PCM recording) in
synchronization with video recording.

Attach the microphone as follows:

1

Loosen the screw of the microphone
holder and open the cover.

2

Set the microphone on the holder with
the UP indication facing up.

3

Close the microphone holder cover for
the original condition to secure, then
connect the microphone cable to the
AUDIO IN connectors (CH-1 and CH-
2) and secure the cable at the cable
clamp under the holder.

Connect the white plug of the supplied
microphone to the CH-1 connector of the
camcorder and the red plug to the CH-2
connector.

4

Set the LINE/MIC/MIC+48V switches
(CH-1 and CH-2) to MIC+48V.

5

Set “EXT CH Select” of “Audio Input”
(page 113)
of the AUDIO SET menu to
“CH-1/CH-2.”

Note

Even when recording CH-1 for 2-channel
monaural by setting “EXT CH Select” of “Audio
Input” (page 113) of the AUDIO SET menu to
“CH-1,” set the LINE/MIC/MIC+48V switch for
CH-2 to the same position as that for CH-1.
However, if a microphone which supports both
stereo and monaural modes is connected and
power of +48 V is supplied to CH-2, the
microphone is not switched to monaural mode,
but the directivity goes the left channel side. For
such a microphone, set the LINE/MIC/MIC+48V

Attaching the
Microphone

Using the Supplied Microphone

PLA

Y/P

AU

SE

F F

WD

1

2

PLA

Y/P

AU

SE

F F

WD

UP

R

L

UP

UP

R

L

1

2

3

Cable clamp

AUDIO

IN

CH-2

MIC

LINE

MIC+48V

CH-1

CH

MIC

LINE

MIC+48V

LINE/MIC/MIC+48V switch

Advertising
This manual is related to the following products: