Sharp MX-M850 - Manual (Page 219)

123
7
Press the [PROOF COPY] key ( ).
One set of copies is printed again using the adjusted settings. Check the results. If further adjustments are needed, repeat
steps 5 through 7. (Repeating Proof Copy does not decrease the remaining number of sets to be printed.)
8
Press the [START] key ( ).
You will return to the base screen of copy mode and the remaining sets will be printed.
To cancel scanning and copying...
Press the [STOP] key (
).
• If Proof Copy is executed while the machine is printing another job, the other job is interrupted and the proof copies are
printed. The previous job will resume after the proof copies are printed.
• If the [End] key is touched to execute printing of the remaining sets while the machine is printing another job, the remaining
sets will be printed after all previously reserved jobs are completed.
• When Proof Copy for 2 sets is combined with Tandem Copy, the proof set is printed by the master machine and only one
set remains. When the [START] key ( ) is pressed, the message appears. Touch the [OK] key to print the remaining set
on the slave machine.
PROOF COPY